Konica Minolta bizhub 4700P User Manual

User's Guide
- 100 -
Use
To
Mac Binary PS
On
Off
Auto
Set the printer to process Macintosh binary PostScript print jobs.
Notes:
• Auto is the factory default setting.
• On processes raw binary PostScript print jobs.
• Off filters print jobs using the standard protocol.
ENA Address
yyy.yyy.yyy.yyy
Set the network address information for an external print server.
Note: This menu is available only when the printer is attached to an external
print server through the USB port.
ENA Netmask
yyy.yyy.yyy.yyy
Set the netmask information for an external print server.
Note: This menu is available only when the printer is attached to an external
print server through the USB port.
ENA Gateway
yyy.yyy.yyy.yyy
Set the gateway information for an external print server.
Note: This menu is available only when the printer is attached to an external
print server through the USB port.
SMTP Setup menu
Use
To
Primary SMTP Gateway
Specify SMTP server gateway and port information.
Note: 25 is the default SMTP gateway port.
Primary SMTP Gateway Port
Secondary SMTP Gateway
Secondary SMTP Gateway Port
SMTP Timeout
5–30
Specify the amount of time in seconds before the server stops trying
to send an e-mail.
Note: 30 seconds is the factory default setting.
Reply Address
Specify a reply address of up to 128 characters in the e-mail sent by
the printer.

Konica Minolta bizhub 4700P Specifications

General

Print Technology	Laser
Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	Up to 150, 000 pages
Maximum Paper Input Capacity	2, 300 sheets
Standard Memory	512 MB
Processor	800 MHz
Duplex Printing	Yes
Connectivity	USB, Ethernet
PDL	PCL 6, PostScript 3
Supported Operating Systems	Windows, Mac, Linux
Hard Drive	Optional