Konica Minolta bizhub 4700P User Manual

User's Guide
- 159 -
Too many flash options installed [58]
1. Turn off the printer.
2. Unplug the power cord from the electrical outlet.
3. Remove the extra flash memory.
4. Connect the power cord to a properly grounded electrical outlet.
5. Turn the printer back on.
Too many trays attached [58]
1. Turn off the printer.
2. Unplug the power cord from the electrical outlet.
3. Remove the extra trays.
4. Connect the power cord to a properly grounded electrical outlet.
5. Turn the printer back on.
Unformatted flash detected [53]
Try one or more of the following:
• From the printer control, select Continue to stop the defragmentation and continue printing. Press
to confirm.
• Format the flash memory.
Note: If the error message remains, then the flash memory may be defective and need to be replaced.
Unsupported option in slot [x] [55]
1. Turn off the printer.
2. Unplug the power cord from the electrical outlet.
3. Remove the unsupported option card from the printer controller board, and then replace it with a
supported card.
4. Connect the power cord to a properly grounded electrical outlet.
5. Turn the printer back on.
Weblink server not set up. Contact system administrator.
Select Continue to clear the message. Press to confirm.

Konica Minolta bizhub 4700P Specifications

General

Print Technology	Laser
Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	Up to 150, 000 pages
Maximum Paper Input Capacity	2, 300 sheets
Standard Memory	512 MB
Processor	800 MHz
Duplex Printing	Yes
Connectivity	USB, Ethernet
PDL	PCL 6, PostScript 3
Supported Operating Systems	Windows, Mac, Linux
Hard Drive	Optional