Konica Minolta bizhub 4700P User Manual

User's Guide
- 92 -
Network/Ports menu
Active NIC menu
Use
To
Active NIC
Auto
[list of available network cards]
Notes:
• Auto is the factory default setting.
• This menu item appears only when an optional network card is installed.
Standard Network menus
Note: Only active ports appear in this menu. All inactive ports are omitted.
Use
To
PCL SmartSwitch
On
Off
Set the printer to automatically switch to PCL emulation when a print job
requires it, regardless of the default printer language.
Notes:
• On is the factory default setting.
• When Off is used, the printer does not examine incoming data. The printer
uses PostScript emulation if PS SmartSwitch is set to On. It uses the
default printer language specified in the Setup menu if PS SmartSwitch is
set to Off.
PS SmartSwitch
On
Off
Set the printer to automatically switch to PS emulation when a print job requires
it, regardless of the default printer language.
Notes:
• On is the factory default setting.
• When Off is used, the printer does not examine incoming data. The printer
uses PCL emulation if PCL SmartSwitch is set to On. It uses the default
printer language specified in the Setup menu if PCL SmartSwitch is set to
Off.
NPA Mode
Off
Auto
Set the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol.
Notes:
• Auto is the factory default setting.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.

Konica Minolta bizhub 4700P Specifications

General

Print Technology	Laser
Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	Up to 150, 000 pages
Maximum Paper Input Capacity	2, 300 sheets
Standard Memory	512 MB
Processor	800 MHz
Duplex Printing	Yes
Connectivity	USB, Ethernet
PDL	PCL 6, PostScript 3
Supported Operating Systems	Windows, Mac, Linux
Hard Drive	Optional