User's Guide
- 127 -
8—Maintaining the printer
Warning—Potential Damage: Failure to maintain optimum printer performance, or to replace parts and
supplies, may cause damage to your printer.
Cleaning the printer
Cleaning the printer
Note: You may need to perform this task after every few months.
Warning—Potential Damage: Damage to the printer caused by improper handling is not covered by the
printer warranty.
1. Make sure that the printer is turned off and unplugged from the electrical outlet.
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock when cleaning the exterior
of the printer, unplug the power cord from the electrical outlet and disconnect all cables from the
printer before proceeding.
2. Remove paper from the standard bin and multipurpose feeder.
3. Remove any dust, lint, and pieces of paper around the printer using a soft brush or vacuum.
4. Dampen a clean, lint-free cloth with water, and use it to wipe the outside of the printer.
Warning—Potential Damage: Do not use household cleaners or detergents to prevent damage to
the exterior of the printer.
5. Make sure all areas of the printer are dry before sending a new print job.
Ordering parts and supplies
Using genuine KONICA MINOLTA parts and supplies
Your KONICA MINOLTA printer is designed to function best with genuine KONICA MINOLTA supplies
and parts. Use of third-party supplies or parts may affect the performance, reliability, or life of the printer
and its imaging components. Use of third-party supplies or parts can affect warranty coverage. Damage
caused by the use of third-party supplies or parts is not covered by the warranty. All life indicators are
designed to function with KONICA MINOLTA supplies and parts, and may deliver unpredictable results if
third-party supplies or parts are used. Imaging component usage beyond the intended life may damage
your KONICA MINOLTA printer or its associated components.
Ordering toner cartridges
Notes:
• The estimated cartridge yield is based on the ISO/IEC 19752 standard.
• Extremely low print coverage for extended periods of time may negatively affect actual yield.
To Next Page
Loading...
Need help?
General
