7-36
Repair manual KTM LC8 Art.-No. 3.206.035-E
Roll angle sensor
A pendulum is positioned in the roll angle sensor that prompts the ECU
to switch off the ignition and injection at an angle of 65º +/- 10º (from
the vertical position); this prevents the engine from running after a
crash. Installation: behind the headlight mask.
Diagnostics connector
The diagnostics connector 1 is located under the seat.
The diagnostics connector connects the KTM diagnostics tool and the
control unit to read error codes or perform function tests.
Side stand switch
The side stand switch 2 is mounted on the side stand console and
relays the position of the side stand to the ECU (for the safety start
system). The side stand switch operates according to the Hall generator
principle.
Clutch switch
The clutch switch 3 is mounted on the clutch pickup instrument and
relays the position of the clutch lever to the ECU (for the safety start
system and idle speed control). The clutch switch is an on/off switch.
Gear switch
The gear switch is mounted on the left side of the engine and relays
the position of the shift roller to the ECU (for safety start system, idle
speed control and EPC). The gear switch is a three-way on/off switch.
The neutral, 2nd gear and 3rd gear positions are relayed.
1
3
2
To Next Page
Loading...
Need help?
General
