3-13
Mounting the engine - 990 Super Duke
– Connect the water, SLS and vacuum hoses to the engine before
mounting (Öttiger clamps - special pliers 600.29.057.000 or
spring-loaded band-type clamps - special pliers 600.29.057.100).
– Position the exhaust system under the motorcycle according to the
installation position.
– Position the swing arm and hold in place with the swing arm bolt on
the right and a suitable pipe on the left.
– Lift the engine into the frame with a floor jack, insert the sealing
washer in the rear exhaust flange and, if necessary, secure with a
small amount of copper paste.
– Run the chain along the side of the pinion and push the swing arm
bolt
1 through the chain, screw on the nut but do not tighten yet.
– Insert the bolt
2 for the lower support through the chain (raise or
lower the engine if necessary).
– Remove the floor jack attachment 600.29.055.100 from the
engine.
– Connect the connectors for the oil pressure switch
3, the
temperature sensor
4 and the front 5 and rear ignition coil. Secure
the wiring harnesses with cable clips.
– Screw on the ground cable terminal
6.
– Insert the short manifold pipe into the exhaust with a new gasket.
– Position the front and rear exhaust manifold on the cylinder head
and slightly tighten the nuts
7 and 8; do not screw tight.
1
2
3
4
5
6
7
8
To Next Page
Loading...
Need help?
General
