2-10
Repair manual KTM LC8 Art.-No. 3.206.035-E
Checking the oil level of the hydraulic clutch - 950/990
Adventure/
950 Supermoto
To check the oil level in the master cylinder of the clutch remove the
cover. For this purpose, remove bolts and cover together with the
rubber boot
1. The oil level in the horizontal-standing master cylinder
should be 4 mm below the upper edge. If necessary add SAE 10
biodegradable hydraulic oil (e.g. Motorex Kupplungs-Fluid 75).
!
CAUTION
!
O
NLY USE
SAE 10 BIODEGRADABLE HYDRAULIC OIL TO REFILL THE MASTER
CYLINDER
. NEVER USE BRAKE FLUID NOR MIX BIODEGRADABLE HYDRAULIC OILS
WITH MINERAL OILS
!
Checking the oil level of the hydraulic clutch - 990 Super Duke
The oil level in the horizontal-standing master cylinder should be
between the "MIN" and "MAX" marks.
If necessary, add SAE 10 biodegradable hydraulic oil (Motorex
Kupplungsfluid 75).
!
CAUTION
!
O
NLY USE SAE 10 BIODEGRADABLE HYDRAULIC OIL TO FILL THE MASTER
CYLINDER
. DO NOT USE BRAKE FLUID AND DO NOT MIX WITH HYDRAULIC MINERAL
OIL
.
Bleeding of the hydraulic clutch
For bleeding, the cover of the master cylinder of the clutch needs to be
removed. For this purpose, remove bolts and take off cover together
with rubber bellows
1. At the slave cylinder of the clutch, remove the
bleeder nipple. At its place, mount the bleeder syringe
2 which is
filled with biodegradable hydraulic oil (e.g. Motorex Kupplungs-Fluid
75).
Refill oil, until oil is discharged from the bore
A of the master cylinder
in a bubble-free state. Make sure that the oil does not overflow.
!
CAUTION
!
H
AVING COMPLETED THE BLEEDING PROCEDURE, YOU HAVE TO VERIFY THAT THE OIL
LEVEL IN THE MASTER CYLINDER IS CORRECT
. FOR FILLING OF THE MASTER
CYLINDER
, USE SAE 10 BIODEGRADABLE HYDRAULIC OIL ONLY (EX. MOTOREX
KUPPLUNGS-FLUID 75); NEVER USE BRAKE FLUID NOR MIX BIODEGRADABLE
HYDRAULIC OILS WITH MINERAL OILS
.
1
2
A
To Next Page
Loading...
Need help?
General
