5-6
Repair manual KTM LC8 Art.-No. 3.206.035-E
1
2
3
Replacing the supporting bearings in the clutch cover
– Pull the bearing shells out of the clutch cover using the puller
151.12.017.000 and the internal extractor 600.29.018.000
1.
– Measure the diameter of the bearing pin at 3 points that are 120°
apart using a micrometer gauge.
Diameter of the supporting bearing pin: 27.985 mm – 28.000 mm
NOTE: The crankshaft must be replaced if the measurement falls short
of the minimum diameter or if the crankshaft is worn.
– Center the new bearing shells with the assembling sleeve
600.29.046.028
2. The assembling sleeve is beveled on one side
so the bearing shells can be pushed in easily. The bearing shells
should protrude 1-2 mm on the other side of the assembling sleeve
to make it easier to position them in the clutch cover.
– Place the bearing shells on the clutch cover with the assembling
sleeve and press in the bearing shells to the stop using the press
mandrel 600.29.046.028
3.
To Next Page
Loading...
Need help?
General
