4-2
Repair manual KTM LC8 Art.-No. 3.206.035-E
1
1
1
2
3
4
4
Clean the engine thoroughly on the outside prior to disassembling.
– Clamp the engine in the work stand using the special tool
600.29.002.000.
Valve covers
– Pull out the spark plug connectors.
– Unscrew the spark plugs using the special tool 600.29.073.000.
– Remove the bolts
1 on the valve covers, remove both valve covers.
– Dismount the gaskets of the bolts, the valve covers and the spark
plug shafts
2.
Spark plug shaft inserts
– Pull the spark plug shaft inserts out of the spark plug shafts (pry out
carefully with 2 screwdrivers if necessary), remove the O-rings
3 (2
pieces for each spark plug shaft) and discard.
Starter motor
– Remove both bolts 4 and pull the starter motor out of the case. The
starter motor is sealed off with an O-ring on the case side.