8-13
INJECTION SYSTEM
Dismounting/mounting the throttle body
(see Chapter 3)
NOTE: never carry out any work on the throttle body; no adjustments
are necessary.
Dismounting/mounting the fuel pump with pressure regulator
and fuel level sensor
– Disconnect the fuel line. To disconnect, press down lightly on the
metal shim
1 and pull the connector off.
– Remove the tank side covers, remove the front tank screw,
disconnect the bleeder line and fold up the tank.
– Disconnect connector
2, remove the lock ring 3 from the damper,
loosen the screws
4 and lift off the tank.
– Loosen the screws
5 on the fuel pump and pull the fuel pump out
of the tank.
– Remount in the reverse order, always replacing the O-rings
6
(lubricated with engine oil) for the fuel pump and fuel connector.
Replacing the fuel filter
NOTE: no prescribed changing interval but recommended if soiled.
– Remove the fuel pump (see above).
– Press the retaining clip
7 towards the outside and pull off the
upper part with the pressure regulator
8.
– Remove and replace the fuel filter
9 and O-ring bk.
– Position the spring
bl in the upper part, mount on the fuel pump
and press tightly until the retaining clip engages.
– Mount the fuel pump (see above).
1
2
3
4
5
7
7
6
8
bk
9
bl
To Next Page
Loading...
Need help?
General
