KTM 690 - Important Maintenance Work to be Carried out by an Authorized KTM Workshop. (as Additional Order); Important Checks and Maintenance Work to be Carried out by the Rider

GREASING AND SERVICE TABLE 28
K05N K15A K45A T1A
Wheels Clean the chain. ( P. 39) • •
Check wheel bearing for play. •
Clean and grease adjusting screws of chain adjuster. • •
K05N: after 500 km (310.7 mi)
K15A: every 1,500 km (932 mi)
K45A: every 4,500 km (2,796 mi)
T1A: daily
7.2Important maintenance work to be carried out by an authorized KTM workshop. (as additional order)
K100A J1A J2A
Carry out a complete fork service. •
Carry out a complete shock absorber service. •
Grease the steering head bearing. •
Change hydraulic clutch fluid. •
Change the crankshaft main bearing. •
Change the transmission bearing. •
Change the balancer bearing. •
Change the timing chain. •
Change the shaft seal rings and gaskets. •
Check wear of all transmission components including shafts. •
Check the crankshaft, connecting rod and cylinder. •
Check the clutch. •
Check the camshaft, rocker arm and valves. •
K100A: every 10,000 km (6,214 mi)
J1A: annually
J2A: every 2 years
7.3Important checks and maintenance work to be carried out by the rider.
NB1A
Check the engine oil level. ( P. 67) •
Check the front brake fluid level. ( P. 42) •
Check the rear brake fluid level. ( P. 47) •
Check the front brake linings. ( P. 43) •
Check the rear brake linings. ( P. 48) •
Check and adjust Bowden cables. •
Bleed fork legs. ( P. 35) •
Clean the chain. ( P. 39) •
Check the chain tension. ( P. 40) •
Check rear sprocket / engine sprocket for wear. ( P. 40) •
Clean the air filter. ( P. 65) •
Checking the tire air pressure. ( P. 53) •
Check the tire condition. ( P. 53) •
Check the coolant level. ( P. 63) •
Empty the carburetor float chamber. •
Check that all operating elements for smooth operation. •
Check braking. •
Check all screws to see if they are tight. •
NB1A: Depending on conditions of use according to requirements.