MAINTENANCE WORK ON CHASSIS AND ENGINE 38
8.24Handlebar position
400361-10
On the upper triple clamp, there are 2 holes at a distance of to each other.
Distance between holes 15 mm (0.59 in)
The holes on the handlebar support are placed at a distance of from the center.
Distance between holes 3.5 mm (0.14 in)
The handlebar can be mounted in 4 different positions. This enables you to mount the
handlebar in the position most suitable for the rider.
The handlebar supports can also be mounted at 2 different heights (with and without
spacer).
Thick spacer 9 mm (0.35 in)
8.25Adjusting handlebar position x
400343-10
– Remove the four screws . Remove the holding plate with handlebar clamps
with intermediate rubber pieces and elastomers .
– Remove the handlebar and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
– Remove the lower shells .
– Remove the clamp bar with the rubber cones .
– Remove the two screws . Remove the handlebar support.
– Check parts for damage and wear. Replace damaged or worn parts.
– Place the handlebar support in the required position. Fit and tighten the two
screws .
Specification
Screw, handlebar support M10 40 Nm
(29.5 lbf ft)
Loctite
®
243™
Condition
Spacer fitted:
Use a M10x35 screw
Condition
Without spacer :
Use a M10x25 screw
Info
Position the left and right handlebar supports evenly.
– Fir the rubber cones and clamp bar .
– Fit the lower shells .
– Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
To Next Page
Loading...
Need help?
General
