ENGINE
L3560, L4060, L4760, L5060, L5460, L6060, WSM
1-S62
[7] SUPPLY PUMP
Supply Pump
• Do not loosen the injection pipe when the fuel is under high
pressure (Within five minutes of stopping the engine).
1. Remove the intake throttle valve assembly (2).
2. Remove the EGR valve assembly (1).
3. Remove the rail (3).
4. Remove the intake manifold (4).
5. Remove the supply pump (5).
• Do not disassemble the supply pump.
• Store the supply pump so it does not get any dust in it.
(When reassembling)
• When attaching the supply crank case, do not put force on
the MPRP and overflow sections of the part.
• Do not remove the dust protection cap until immediately
before you attach the part.
9Y1210824ENS0046US0
[8] WATER PUMP AND OIL COOLER
Water Pump
1. Remove the pipe band and the water pipe (water pump side).
2. Remove the water pump (1).
(When reassembling)
• When mounting the water pump, be careful not to forget
mounting the O-ring and not to let it out of position.
9Y1210824ENS0047US0
Tightening torque
Supply pump mounting nut
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
Injection pipe retaining nut
24.5 to 29.0 N·m
2.5 to 3.0 kgf·m
18.1 to 21.3 lbf·ft
(1) EGR Valve Assembly
(2) Intake Throttle Valve Assembly
(3) Rail
(4) Intake Manifold
(5) Supply Pump
(1) Water Pump
To Next Page
Loading...
Need help?
General