ELECTRICAL SYSTEM
L3560, L4060, L4760, L5060, L5460, L6060, WSM
9-S21
(4) Mode "C" (PTO Coefficient Number Input Mode) Input the Numeric Code
Number for PTO Speed into the Electronic Instrument Panel
• When the electronic instrument panel is replaced, this
operation is required.
1. While holding down the display mode switch, turn on the main
switch.
2. Mode selection display (a) is indicated on the LCD.
3. Press the display mode switch. The buzzer rings and the
marked display moves.
4. Select the Mode "C".
5. Hold down the display mode switch for more than 2 seconds.
6. PTO Coefficient No."1" "2" "3" "4" is displayed (b).
(Numerical Modification)
• Set the desired PTO coefficient as follow :
• Each time the display mode switch is pressed, the marked
display shifts to the next digit. Shift the marked display to the
desired position.
7. Hold down the display mode switch more than 2 seconds.
8. When the PTO coefficient has been input, hold down the display
mode switch for more than 2 seconds to preserve the PTO
coefficient No. in the panel's memory.
9. "OK" is displayed (d) : The operation coefficient has been input
correctly.
10. If "NG" is displayed: Incorrect input. Repeat the procedure.
11. Turn off the main switch.
9Y1210824ELS0014US0
Operation Coefficient No. Tractor Model Transmission Model
1
L3560, L4060, L4760,
L5060
Manual transmission
GST
L3560 HST
2 L4060 HST
3 L4760 HST
4 L5460, L6060 HST
(a) Mode Selection Display
(b) Input Display
(c) Confirmation Display
To Next Page
Loading...
Need help?
General