ELECTRICAL SYSTEM
L3560, L4060, L4760, L5060, L5460, L6060, WSM
9-S84
(10) Intake Throttle Valve
• Firstly check the connector voltage, secondly check the other wires continuity, then finally check the
sensor resistance.
9Y1210824ELS0119US0
Connector Voltage
1. Disconnect the connector, and turn the main key switch "ON"
position.
2. Measure the voltage with a voltmeter across the terminals
shown in the table below.
3. If the reference value is not indicated as shown in the table
below, check the relating electric circuit.
9Y1210824ELS0120US0
Motor Resistance
1. Disconnect the throttle valve connector.
2. Measure the resistance with an ohmmeter across the terminal 5
and 6.
3. If the reference value is not indicated as shown in the table
below, DC motor is faulty.
9Y1210824ELS0121US0
Voltage
Main switch at
"ON"
Terminal 3 –
chassis
Approx. battery
voltage
(1) Intake Throttle Valve (2) Connector (Harness Side)
Resistance Terminal 5 – 6 Approx. 12 Ω
(1) Connector (Sensor Side)
To Next Page
Loading...
Need help?
General