ELECTRICAL SYSTEM
L3560, L4060, L4760, L5060, L5460, L6060, WSM
9-M36
(Continued)
(4) Engine warning
This indicator serves the following two functions. If
the indicator lights up, pinpoint the cause and take a
proper measure.
1. Error with the engine control system
If during operation the water temperature gauge
reads an acceptable level but the warning lamp in
the Easy Checkerâ„¢ comes on, stop the engine and
get it restarted. If the error happens again, check the
engine.
• If the warning indicator lights up, the following
phenomena may appear depending on the
engine's trouble spot.
a) The engine stops unexpectedly.
b) The engine fails to start or gets interrupted
just after start.
c) The engine output is not enough.
d) The engine output is enough, but the warning
indicator stays on.
• If the engine output is not enough, immediately
interrupt the operation and move the tractor to a
safe place and stop the engine.
2. Engine overheat
If the water temperature gauge reads an unusual
level and the warning lamp in the Easy Checkerâ„¢
comes on, the engine may have got overheated.
Check the cooling system.
(5) Emission indicator
If emission indicator lights up, take the steps to lower
the water temperature. This helps keep the emission
clean.
9Y1210824ELM0059US0
(6) Confirmation Display
Fuel Level Warning
If the fuel in the tank goes below the prescribed level
(less than approximate 6 L, 1.5 U.S.gals, 1 Imp.qts),
"REFUEL" is displayed on the LCD (1) in the panel will
come on. If this should happen during operation, refuel
as soon as possible.
9Y1210824ELM0060US0
(1) LCD (Liquid Crystal Display)
To Next Page
Loading...
Need help?
General