TRANSMISSION
L3560, L4060, L4760, L5060, L5460, L6060, WSM
3-S47
Propeller Shaft
1. Slide the propeller shaft cover (4) and (8) after removing the
screws (7).
2. Tap out the spring pins (2), (6) and slide the couplings (1), (5)
and then remove the propeller shaft with covers (4), (8).
(When reassembling)
• Apply grease to the splines of propeller shaft (3).
9Y1210824FAS0009US0
[2] CABIN TYPE
(1) Separating Cabin from Tractor
Draining the Transmission Fluid
• Allow the engine to cool down sufficiently, oil can be hot
and burn.
1. Place oil pans underneath the transmission case.
2. Remove the drain plugs (1).
3. Drain the transmission fluid completely.
4. Reinstall the drain plugs (1).
(When refilling)
• Fill up from filling port after removing the filling plug (2) until
reaching the upper notch on the dipstick (3).
• After running the engine for a few minutes, stop it and check the
oil level again, add the fluid to prescribed level if it is not correct
level.
HST
• Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system. (Refer to "4.
LUBRICANTS, FUEL AND COOLANT" on page G-9.)
• Do not mix different brands of fluid together.
9Y1210824CLS0013US0
(1) Coupling
(2) Spring Pin
(3) Propeller Shaft
(4) Propeller Shaft Cover
(5) Coupling
(6) Spring Pin
(7) Screws
(8) Propeller Shaft Cover
Transmission fluid
capacity
L3560
42 L
11.1 U.S.gals
9.24 Imp.gals
L4060
L4760
43 L
11.4 U.S.gals
9.5 Imp.gals
L5460
L6060
45 L
11.9 U.S.gals
9.90 Imp.gals
(1) Drain Plugs
(2) Filling Plug
(3) Dipstick
A: Oil level is acceptable within this
range.
To Next Page
Loading...
Need help?
General