FRONT AXLE
L3560, L4060, L4760, L5060, L5460, L6060, WSM
6-S8
Front Wheel and Front Axle Assembly
1. Check the front axle and engine are securely mounted on the
disassembly stand.
2. Loosen the front wheel mounting nuts.
3. Lift the front axle and remove the front wheels.
4. Remove the bracket (front) mounting screws and nuts.
5. Remove the bracket (rear) mounting screws and nuts.
6. Separate the front axle from front axle bracket.
(When reassembling)
• Be sure to adjust the front axle rocking force. (See page
6-S6.)
9Y1210824FAS0011US0
[2] DISASSEMBLING FRONT AXLE
Draining Front Axle Case Oil
• Be sure to stop the engine before changing the front axle
case oil.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the right and left drain plugs (3) and filling plug (2) at
the front axle case and drain the oil completely.
2. After draining, reinstall the drain plugs (3).
(When refilling)
• Remove the right and left check plugs (1).
• Fill new oil from filling port with specified amount of oil.
• Reinstall the filling plug (2) and check plug (1).
• Use KUBOTA SUPER UDT fluid or SAE80, 90 gear oil.
Refer to "4. LUBRICANTS, FUEL AND COOLANT" on page
G-9.
9Y1210824FAS0012US0
Tightening torque
Front wheel mounting nut
137 N·m
14.0 kgf·m
101 lbf·ft
Bracket
mounting
screw and
nut
L3560
L4060
L4760
L5060
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
L5460
L6060
103 to 117 N·m
10.5 to 12.0 kgf·m
76.0 to 86.7 lbf·ft
Capacity
Front axle
case oil
L3560
L4060
6.5 L
6.9 U.S.qts
5.7 Imp.qts
L4760
L5060
L5460
L6060
8.5 L
9.0 U.S.qts
7.5 Imp.qts
(1) Check Plug
(2) Filling Plug
(3) Drain Plug
To Next Page
Loading...
Need help?
General