TRANSMISSION
L3560, L4060, L4760, L5060, L5460, L6060, WSM
3-S112
Hydraulic Pipe and Wiring Harness
1. Disconnect the speed sensor connector (1).
2. Disconnect the PTO clutch valve connector (2).
3. Disconnect the proportional valve connector (3).
4. Remove the brake rod R.H. (5).
5. Remove the PTO delivery pipe (4).
6. Disconnect the solenoid valve connector (7).
7. Set aside the main wiring harness (6) to the front.
9Y1210824TRS0112US0
Separating Mid Case and Transmission Case
1. Separate the mid case and transmission case after removing
their mounting screws.
(When reassembling)
• Make sure to insert the PTO shaft to PTO clutch firmly, turning
the PTO shaft.
• Apply liquid gasket (Three Bond 1208C or equivalent) to joint
face of the mid case and transmission case.
9Y1210824TRS0113US0
Tightening torque
Joint bolt for PTO delivery
pipe
35 to 39 N·m
3.5 to 4.0 kgf·m
26 to 28 lbf·ft
Joint bolt for HST return
pipe
88 to 98 N·m
9.0 to 9.9 kgf·m
65 to 72 lbf·ft
(1) Speed Sensor Connector
(2) PTO Clutch Valve Connector
(3) Proportional Valve Connector
(4) PTO Delivery Pipe
(5) Brake Rod R.H.
(6) Main Wiring Harness
(7) Solenoid Valve Connector
Tightening torque
Mid case and transmission
case mounting screw
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
Mid case and transmission
case mounting nut
103 to 117 N·m
10.5 to 12.0 kgf·m
76.0 to 86.7 lbf·ft
To Next Page
Loading...
Need help?
General