GENERAL
L3560, L4060, L4760, L5060, L5460, L6060, WSM
G-22
Replacing Engine Oil Filter
• Be sure to stop the engine before changing the oil filter
cartridge.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the oil filter.
2. Put a film of clean engine oil on the rubber seal of the new filter.
3. Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil normally
decreases a little. Make sure that the engine oil does not leak
through the seal and be sure to check the oil level on the
dipstick. Then, replenish the engine oil up to the prescribed
level.
• To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
9Y1210824GEG0029US0
Replacing Transmission Oil Filter (HST)
• Be sure to stop the engine before changing the oil filter
cartridge.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the drain plugs at the bottom of the transmission case
and drain the oil completely into the oil pan.
2. After draining reinstall the drain plugs.
3. Remove the oil filter.
4. Put a film of clean transmission oil on the rubber seal of the new
filter.
5. Quickly tighten the filter until it contacts the mounting surface,
then, with a filter wrench, tighten it an additional 1 turn only.
6. After the new filters have been replaced, fill the transmission oil
up to the upper notch on the dipstick.
7. After running the engine for a few minutes, stop the engine and
check the oil level again, add oil to the prescribed level.
8. Make sure that the transmission fluid does not leak past the seal
on the filter.
• To prevent serious damage to the hydraulic system, use
only a KUBOTA genuine filter.
9Y1210824GEG0030US0
(1) Engine Oil Filter
(1) Drain Plug
(2) Transmission Oil FIlter (HST)
(3) Gauge
(4) Oil Inlet
A: Oil level is acceptable within this
range.
To Next Page
Loading...
Need help?
General