10-3
4.
Install the front bumper and front fender
panel.
5.
FiJI
the cooling system with the
recommended amount
of
antifreeze.
Check
for
leakage.
6. Connect the fan wiring to the main wiring
harness.
Standard:
Radiato•·
& hoses
Coolant
Re
servoir
3000cc
300cc
HOSES/THERMOSTAT
REMOVING
1.
Dra
in approximately one quart
of
coolant
from the cooling system.
2. Remove the two cap
sc
rews securing the
thermostat housing to the cylinder head.
Account for an 0 -ring and a thermostat.
INSPECTI
NG
*
W11ene
ver a part ts worn excessively,
cracked, or damaged
1n
any way,
replacement is necessary.
1.
In
spect the thermostat for corrosion, wear,
or spring damage.
2.
Using the following procedure, inspect
the thermostat
for
proper operation.
A. Suspend the thermostat
in
a
co
ntainer
filled with water.
B.
Heat
the water and monitor the
temperature w
it
h a thermometer,
C. The thermostat should start to open at
80-
84
oc
(176-
183 °F), fully open at
95
oc
(203 °
F).
D.
lf
the thennostat does not open, it must
be replaced.
3. Inspect
all
cool
ant
hoses, connections,
and clamps for deterioration, cracks and
wear.
*--------------,
All coolant hoses and clamps should
be
.
replaced every four years or
4000
miles.
501k
~96001
19505
~
315
~~
C)
19317
'--::-'
19505
0;
0
19300
~
19507 19316
~
'
"''~~~
To Next Page
Loading...
Need help?
General
