About X-431 Station
Diagnostics
Toolbox & Apps
FAQ
Initial Use
22
www.x431.com +86 755 8455 7891
LAUNCH
Station
User's Guide
2.2.3 Network Setup
The diagnostic tool has built-in Wi-Fi that can be used to get online. Once you’re online, you can register
your tool, update diagnostic software & APK, browse the Internet and send email on your network.
1. On the Home screen, tap or click
(or go to -> “WiFi & Network” -> “WiFi”).
2. Move the Wi-Fi switch to ON, the tool starts searching for available wireless LANs.
WiFi Setup Screen
3. Select the desired Wi-Fi network from the list. If the chosen network is open, you can connect directly. A
password may be required for secured networks.
2.2.4 Remote Control Pairing Up
A dedicated remote control is provided for the user with quick access to perform all kinds of actions. To
ensure it works properly, a Bluetooth communication should be establised between the remote control and
the diagnostic tool. Follow the steps below to proceed.
1. On the Home screen, tap or click
(or go to -> “Bluetooth & peripherals” -> “Bluetooth”).
2. Hold and press the [OK] and [
] (Menu) buttons at the same time and then release them, the tool starts
searching for it (The Bluetooth ID of the remote control is Phoenix One Remote) and automatically pairs
it up.
OK
Bluetooth Setup Screen
3. After it is successfully connected to the tool, it will appear in the “Connected Bluetooth device” list. Now
the remote control is ready for use.
To Next Page
Loading...
Need help?
General
