200 GPS1200 NTRIP via Internet
25.2.3 Using the NTRIP Service with a Real-Time Rover
Requirements The configurations from the previous chapter must have been completed. Refer to
"25.2.2 Configuring to Connect to a Server".
Use NTRIP service
step-by-step
Step Description
1. Select Main Menu: Config...\Interfaces....
2. In CONFIGURE Interfaces highlight Real-Time.
3. EDIT (F3) to access CONFIGURE Real-Time Mode.
4. CONFIGURE Real-Time Mode
<Port: NETx> must be selected.
5. ROVER (F2) to access CONFIGURE Additional Rover Options.
6. PAGE (F6) to access CONFIGURE Additional Rover Options, NTRIP
page.
7. CONFIGURE Additional Rover Options, NTRIP page
8. <Use NTRIP: Yes>
<User ID:> A user ID is required to receive data from to the NTRIP Caster.
Contact the NTRIP administrator for information.
<Password:> A password is required to receive data from the NTRIP
Caster. Contact the NTRIP administrator for information.
9. SRCE (F5) to access CONFIGURE NTRIP Source-Table.
10. CONFIGURE NTRIP Source-Table
All MountPoints are listed. MountPoints are the NTRIP Servers sending
out real-time data. This screen consists of two columns:
• First column MountPoint:
The abbreviations for the MountPoints.
• Second column Identifier:
The city where the MountPoint is located.
11. Highlight a MountPoint about which more information is required. This
information helps to configure the receiver to use the selected MountPoint
as a reference.
12. INFO (F3) to access CONFIGURE MountPoint: XX.
13. CONFIGURE MountPoint: XX, General page
<Format:> The real-time data format sent out by the MountPoint.
<FormatDet:> Details about <Format:>, for example the RTCM message
types including update rates in seconds displayed in brackets.
<Authentic:> The type of password protection required for the authorisa-
tion to the NTRIP Server. <Authentic: None> if no password is required.
<Authentic: Basic> if the password need not be encrypted. <Authentic:
Digest> if the password must be encrypted.
<NMEA:> Indicates if the MountPoint must receive GGA NMEA data from
the rover in order to compute VRS information.