Information SET-01 15
DIGITAL plus
5 Overview of the functions of LH100
This section will provide you:
- a short overview of each of the functions of LH100.
Specific details for using each feature follows in subsequent
subsections, which follow this section.
5.1 Controlling locomotives
5.1.1 Selecting locomotive addresses
There are 3 different ways to select a locomotive address. Up to
9999 addresses for digital locomotives are available to you. With
address 0 you control a conventional locomotive in the digital
operation. More about entering and selecting locomotive addresses
can be found in the section "Entering a new locomotive address on
the LH100 keypad" starting on page (ðp.20 ).
5.1.2 Changing speed and direction of travel
You change the speed and the direction of travel of the locomotive
with specially shaped keys described in the section "Changing
locomotive speed and direction" starting on page (ðp.20 ).
5.1.3 Emergency stop
With the emergency stop you bring one or all locomotives to an
immediate stop described in the section "Emergency stop and
emergency off" starting on page (ðp.28 ).
5.1.4 Turning locomotive functions on and off
You can access up to 13 functions in each locomotive decoder.
You can also determine if the function operates as a on/off or
momentary function. How you control locomotive functions is
described in the section "Activating locomotive functions" starting
on page (ðp.24 ).
5.1.5 Setting the Throttle-notches for a particular locomotive
With the LH100 you can select 14, 27, 28 or 128 Throttle-notches
for the currently selected locomotive address. (Depending on the
software version of `the command station you are using). This
information is stored in the command station for subsequent use.
How you select the different Throttle-notches and match it to your
locomotive decoder is shown in section "Showing and changing
throttle-notches" starting on page (ðp. 26 ).
To Next Page
Loading...
Need help?
General
