Lenz Digital plus SET-01/4 User Manual

42 Information SET-01
11.7 Erasing a completed MU
If you want to remove all the locomotives from a MU at one time
then proceed as follows:
Press On the display you see Explanation
First call up the MU address
(shown by a capital “M”).
Display shows the most
recently selected menu
You are prompted to erase this
MU.
Flashes
This display flashes. You have
the last opportunity to interrupt the
erasing with ‘Esc’.
'Enter' starts the disassembly.
Each individual locomotive
addresses in the MU is displayed
and erased from the consist.
Finally the consist address is
shown as an individual locomotive
address.
11.8 Error messages in multi-unit consists
If you made an error when assembling the multi-unit consist, you
will see one of the following messages in the display:
ERR 24 The locomotive was not selected or no command to the
locomotive was sent prior to setting up the MU/double
header.
ERR 25 One of the locomotives of the MU/double header is being
operated on another Handheld.
ERR 26 One of the locomotives is already part of another MU/double
header.
ERR 27 One of the two locomotives was not at throttle position 0.
Locomotives must be stopped before you can combine them
into a consist.
Press the ‘Cl’ key to clear the error message from the display and
return to locomotive control.

Lenz Digital plus SET-01/4 Specifications

General

Brand	Lenz
Model	Digital plus SET-01/4
Category	Control Unit
Language	English