Information SET-01 45
DIGITAL plus
If the turnouts are not feedback capable, or connected to a non-
feedback capable accessory decoder, then you can’t have actual
feedback of the turnout position. In this case you will see the last
entered position (+ or -) when you call up the turnout. And when you
press the + or - keys, the display will update immediately.
If after entering for instance the turnout address ‘118’ you see this
display
then this address is not an accessory decoder, but a feedback
encoder LR100.
In this case pressing the ‘+’ or ‘-’ key will have no effect. Using the
‘Cl’ key you can get back to entering a new turnout address, using
‘Esc’ you can get back to controlling locomotives. Information about
displaying the status on feedback encoders is in section "Displaying
feedback" starting on page (ðp.46 ).
12.2 Train operation while controlling turnouts or
signals
While displaying a turnout address and its status, you can still use
the operation keys to control the most recently called up
locomotive.
When you press one of the operation keys, this locomotive address
or speed is shown in the display. The turnout's address is shown
when you stop pressing the key.
The locomotive's address’ direction arrow and the status of the
decoder functions are always shown in the display. This way you
can still control the selected locomotive even while you throw
turnouts and set signals. This allows you to comfortably execute
yard switching operations.
To Next Page
Loading...
Need help?
General
