Repair information 4-65
5025-2xx, 4xx
Paper pick motor drive assembly removal—standard tray
See “Paper pick motor drive assembly—standard tray” on page 7-5 for the part number.
1. Remove the toner cartridges, the waste toner bottle, and the imaging unit (IU). See “Waste toner bottle
removal” on page 4-81, and see “Imaging unit (IU) removal” on page 4-49.
2. Remove the left cover. See “Left cover assembly removal” on page 4-6.
3. Remove the rear shield. See “Rear shield removal” on page 4-11.
4. Disconnect the paper pick motor drive assembly cable connector (A) fromJSP1 on the controller board.
5. Pull the cable (B) through the opening, and free the cables from the retainers (C) on the left side.
6. Partially reinstall the rear shield to protect the controller board, and turn the printer so the rear shield rests
on the table and the bottom is facing you.
Warning: For models with a wireless antenna, use supports to prevent the antenna from taking the weight
of the printer.
To Next Page
Loading...
Need help?
General
