Driving modes
6.1 Driving modes
6 - 2 3 302 690 en Operating manual
GMK4100L-1
23.11.2017
6.1.1 How to use the tables
H
This section only shows some standard driving modes. For further
information on additional or individual driving modes, please contact
Manitowoc Crane Care.
The tables consist of two parts:
– The driving mode of your truck crane is specified in the top part, next to
Equipment. Find out which driving mode applies to your truck crane.
– The required rigging mode for this driving mode and the accessories you
are allowed to transport are specified in the lower section, next to Rigging
mode.
Example of how to use the table:
Assuming your truck crane is equipped with 385/95 tyres, 8 x 6 x 8 drive, tans-
mission retarder and auxiliary hoist.
In this case the driving mode in the upper part, next to equipment is 1, 3 and 5.
Assuming you are drive while in driving mode 3 – according to the specifications
in the bottom part, next to the rigging mode,
– the steel outrigger pad installed,
– the 1-sheave hook block may be attached to the front bumper,
– a 3.7 t counterweight may be mounted on the rear counterweight platform.
Additional parts must be transported on a separate vehicle.
H
If you remove indicated parts from the truck crane in driving mode, then the
total weight decreases but might be distributed in such a way that the front
or rear axle loads are over 12 t.
To Next Page
Loading...
Need help?
General
