Special Attention
Do not leave open food, sun tan oil, or other materials on the seats
if the seat heat function is ON. Although the heat does not exceed a
temperature at which skin can touch without burning, nonetheless
the additional heat could cause some types of food or other mate-
rials to melt, causing a stain or damage that is not covered under
warranty.
Do not leave unattended, open food or other materials that could
melt, on a seat equipped with a seat heater that is or will be turned
ON. The additional heat could cause melting, resulting in a stain or
other damage that is not covered under warranty.
Troubleshooting
If the seat heat system does not work when the switch is ON, check
at the main circuit breaker panel to ensure the circuit has not
tripped. If so, reset. If the seat heater(s) still does not work or if the
circuit continues to trip, take the boat to an authorized MasterCraft
dealer.
ANCHOR
Models
All, as an option
Purpose
The anchor allows the boat to be temporarily moored in relatively
shallow water. Note that standard equipment does not include the
line for the anchor. This is because needs will vary considerably by
location of the body of water. The general rule of thumb is that the
boat owner should purchase anchor line from a marine aftermarket
company at a length about three-to-four (3-4) times the depth of
the body of water in which the boat will be moored.
Location
Some models are equipped with anchors, and there will be a desig-
nated storage area or stowage location on the boat, normally in the
forward area of the bow. Check with your dealer if you are uncertain
about this area because it is important to keep the anchor stowed
To Next Page
Loading...
Need help?
General
