Extended Storage (In Excess Of One Year)
Follow the recommendations listed above for storage of several
months duration. Additionally:
• Check the brake system for fluid level in the master cylinder. If the
fluid level is low, air may be trapped in the brake lines. Bleed all
lines if necessary and fill the reservoir to the proper level.
• Lubricate all links and pivots to prevent rusting.
• Fill the frame (to avoid damage from vermin).
• Be certain the breakaway system has not been set and that the
actuator is fully extended.
• When possible, store away from excessive moisture.
Troubleshooting
If any of the following potential problems develop, the trailer must
be immediately stopped and the proper corrective action taken
before the trailer is placed back in service. Failure to do so may
lead to loss of proper trailer braking capability or damage to the
trailer and load.
Coupler Latch Handle Not Opening Or Closing Easily
Possible Cause Remedy
Ball not fully inserted
in ball socket
Check for the proper ball size and
positive tongue load. Check to see if
the tongue jack is fully retracted. Make
sure there are no foreign objects or
excessive points inside the coupler
cavity.
Trailer and tow
vehicle not level with
each other or facing
downhill
Reposition the tow vehicle and trailer
or block a trailer tire and extend the
actuator.
Oversize hitch ball Check ball size at several positions.
The ball should be within 1.970”-2.000”
in diameter. Replace if necessary.
Excessive corrosion Lubricate or replace parts as neces-
sary.
Ball clamp
interference
This condition can occur on certain
styles/types of ball mounts. Replace
as necessary, or lift the coupler slightly
to enable the clamp to slide past the
interference, then let the coupler back
down.
To Next Page
Loading...
Need help?
General
