Checking And Resetting The Breakaway Cable
To retract or release the breakaway cable, remove the plastic cap on
top of the actuator. Verify the E-stop (breakaway cable) is “set”, with
the cable bracket toward the rear of the opening. To release, press
on the forward E-stop release bracket (front of opening) with your
finger or a screwdriver until the E-stop cable bracket snaps back
into the forward, disengaged position. A screwdriver may be needed
to assist in prying the cable bracket forward.
The breakaway system must be reset anytime the cable has been
pulled.
(See the lockout information elsewhere in this section of the Own-
er’s Manual.)
Trailer Winch Assembly
Maintain a firm grip on the winch handle at all times. Never release
the handle when the ratchet level is in the unlocked position with
a load on the winch because the handle will spin forcefully under
these conditions, which may cause serious injury. Also, if the winch
is released and begins to spin forcefully, do NOT attempt to halt
the spin.
4
TDE MODEL
LP8000
SAE CLASS IV
MAX GVW
8000 LBS
5
TDE MODEL
LP8000
SAE CLASS IV
MAX GVW
8000 LBS
6
TDE MODEL
LP8000
SAE CLASS IV
MAX GVW
8000 LBS
To Next Page
Loading...
Need help?
General
