EasyManuals Logo
Home>MasterCraft>Boat>X23

MasterCraft X23 User Manual

MasterCraft X23
438 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #278 background imageLoading...
Page #278 background image
3. Insert key into pump switch panel located under this seat.
4. Turn the key clockwise and hold to operate the discharge pump.
The switch is spring loaded and must be held to run the pump.
5. Run the pump until the tank level monitor reads empty.
6. Close the overboard shutoff valve.
7. The overboard discharge pump is located in the same area as the key
switch, under the starboard side bow lounge seat in front of the driver.
Cleaning the toilet
To maintain the toilet’s original appearance, use Dometic® Toilet Bowl
Cleaner or other non-abrasive bathroom and toilet bowl cleaners.
Please follow label directions.
Caution To avoid damaging internal seals, do not clean toilet with
abrasive cleaners, caustic chemicals, or lubricants and cleaners
that contain alcohols or petroleum distillates.
Routine maintenance
MONTHLY
1. Inspect toilet, plumbing, and plumbing connections, wires, and wire
connections.
2. Open and close all plumbing valves, including seacocks.
3. Check in-line water filters and vented loops for blockage.
YEARLY
Check water valve filter. Also check water valve filter if water flow
into toilet becomes insufficient.
During extended periods of non-use
The macerator toilet and sanitation hoses should be protected if
toilet will not be needed for an extended period of time (more than
two weeks, especially in hot weather).
1. Flush toilet and add 4 oz. (118 ml) of liquid biodegradable laundry
detergent (should NOT con tain bleach or environmentally harmful
substances). Note: If using sea water for flushing, shut off power to
sea water pump and add fresh water directly into the bowl during
the flush cycle.
2. Flush toilet at least five times.
3. Turn off water supply to toilet.
4. Flush the toilet without water very briefly to evacuate all water.
(This procedure will minimize any remaining water in the macerator
pump.)
5. Turn off power to the toilet.
6. After extended periods of non-use, toilet and pump may dry. For
easier re-start of toilet system, add one quart of water to bowl and
let it stand for a few minutes before use.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MasterCraft X23 and is the answer not in the manual?

MasterCraft X23 Specifications

General IconGeneral
BrandMasterCraft
ModelX23
CategoryBoat
LanguageEnglish

Related product manuals