Another attractive feature on some boat models is the folding arm
rest, normally found in the bow section. These arm rests are padded
with attractive upholstery material, which requires the same type
of care as all of the boat’s upholstery. (See Care and Maintenance
upholstery information in this Owner’s Manual.)
GAS ASSISTED SEAT LIFT
Models
X2, X10, X20, X23, X26, X30, and XStar, as an option
Purpose
Allow the helm seat to raise and lower ~3” to accommodate different
operator seat height preferences.
Location
Helm Seat
Operation
Lift the handle on the seat pedestal located on the outboard side
of the pedestal. To raise, lift handle and remove body weight and
the seat will extend up. To lower, lift handle while applying weight to
the seat to compress the gas assisted mechanism inside. Release
handle between the topmost and lowest position to set and hold the
seat height.
CONVERTIBLE CENTER REAR SEAT
Models
X10, X20, X23, X26, X30, X46 and XStar, as an option
Purpose
Allow the option of occupants to sit forward facing, rear facing or
create a center cockpit sunpad.
Location
Aft section of the cockpit.
Operation
The seat has a sliding/locking pivot connecting the seat back to the
seat cushion.
Forward to Rear Facing and vice versa: Lift sharply up on the handle
at the top of the seat back to lift off the “Lock” position. Hold the
handle while lifting the seat back up and away from its current
To Next Page
Loading...
Need help?
General
