Mercury FourStroke 3.5 User Manual

Tiller Handle
90-8M0065421 NOVEMBER 2012 Page 7B-11
7. Apply Loctite 242 Threadlocker to the fuel tank mounting bolts. Install the bolts and washers. Tighten the bolts to the
specified torque.
a - Fuel tank
b - Bolt and washer (M6 x 25) (3)
Tube Ref No. Description Where Used Part No.
66
Loctite 242 Threadlocker Fuel tank mounting bolts 92-809821
Description Nm lb‑in. lb‑ft
Fuel tank mounting bolts (M6 x 25) (3) 6 53
8. Install the top cowl.
Throttle Cable Adjustment
Deceleration Cable
1. Rotate the grip to the "START" position.
2. Loosen the jam nuts on both throttle cables.
3. Pull the choke knob out completely.
4. Pull the outer cable jacket in the direction of the arrow.
5. Tighten the deceleration throttle cable jam nuts.
6. Gently push the inner wire. The wire should deflect approximately 1 mm (0.040 in.).
7. Push the choke knob in completely.
8. The idle screw must contact the throttle stop.
a - Deceleration cable
b - Throttle stop
c - Idle screw
50010
a
b
b
b
41820
a
b
c

Mercury FourStroke 3.5 Specifications

General

Brand	Mercury
Model	FourStroke 3.5
Category	Outboard Motor
Language	English