Miele H6260BP - Descaling the Steam Injection System

Cleaning and care
107
Descaling the steam injection
system
When to run the descaling process
The frequency of descaling will depend
on the water hardness level in your
area.
The descaling process can be run at
any time.
However, to ensure that the oven
functions correctly, you will be
automatically prompted to run the
descaling process after a certain
number of programmes.
If Moisture Plus is selected, a
prompt to run the descaling process will
appear in the display.
 

You can use the Moisture Plus
function 10more times before
descaling. After the 10th programme,
the function will be locked and cannot
be used until descaling is carried out.
The prompt will disappear after a few
seconds. You can also dismiss it by
touching OK.
All other oven functions can still be
used.
The number of cooking processes
available until the function locks out will
count down in the display until  and
 appear.




After that the Moisture Plus
function is locked and can only be used
again after the descaling process has
been carried out.
Descaling process sequence
Once the descaling process has been
started, it must be completed through
to the end. It cannot be cancelled.
The descaling cycle takes approx.
90minutes and consists of several
steps:
  Drawing in the descaling solution
  Activation phase
  Rinse 1
  Rinse 2
  Rinse 3
  Evaporating residual moisture