Factory Default Settings
You can return the switch to its factory default settings. Use the end of a paper clip or some other similar
object to press and hold the RESET button on the bottom panel of the switch for more than five seconds.
The switch resets and returns to the factory settings that are shown in the following table.
Table 4. Factory default settings
Default SettingFeature
Access point login and discovery
DHCP client. Enabled. That is, an IP address is issued to the switch by a DHCP
server in the network.
Standalone IP address. 192.168.0.239 with subnet mask 255.255.255.0.
IP address
passwordLogin password
All enabled (UPnP, Bonjour, and NSDP)Switch discovery protocols
QoS
Port-BasedQoS mode
Medium (P4) (all ports)Port priority
None (for all ports)Port rate limits
DisabledFlow control
DisabledBroadcast filtering
None (for all ports)Port storm control rate limits
Multicast
EnabledIGMP snooping
NoneVLAN ID enabled for IGMP
snooping
DisabledBlocking of unknown multicast
addresses
DisabledIGMPv3 IP header validation
NoneStatic router port for IGMP
snooping
Ports and LEDs
AutonegotiationPort link speed
EnabledPort LEDs
Factory Default Settings and Technical Specifications
82
Nighthawk Pro Gaming SX10 Switch Model GS810EMX
To Next Page
Loading...
Need help?
General
