NXAMPMK2 USER MANUAL PAGE 19 / 80
CONFIGURATION WITH TWO SPEAKERS 1+/1-
In that case, we will take two L15 subwoofers (taking the signal from 1+/1-), recalled on amplifier CH1 and
CH2.
In that configuration, the cabling is straight forward, CH1 is taken from speakON A and CH2 is taken from
speakON B.
SD
and amplifier is not crossing channels.
CONFIGURATION WITH ONE SPEAKER 1+/1- & ONE SPEAKER 2+/2-
In that case, we will take one L15 subwoofer (taking the signal from 1+/1-) and one P12 speaker in passive
mode (taking signal from 2+/2-), recalled respectively on amplifier CH1 and CH2.
SD
influence in this case, and amplifier is not crossing channels.
Because there is only one speakON plug on the amplifier, the LINK plug on the speaker can be used by
entering first the L15 and then link to P12 (or entering first the P12 and then link to L15).
Note: An Y speakON adaptor can be used on speakON A if both speaker lines are not going to the same
direction, and then save cable length.
For 2 channels active speakers, this is the same situation. For example, if we load P12_LF on CH1 and
P12_HF on CH2, the speaker has to be connected to speakON A. Oppositely, if we load P12_LF on CH2
and P12_HF on CH1, the speaker has to be connected to speakON B.
To Next Page
Loading...
Need help?
General
