PAGE 48 / 80 NXAMPMK2 USER MANUAL
INPUT PINS CONFIGURATION
In Custom Mode, to configure the input pins (control functions), press GPInputs.
Then select the desired input pin (numbered from GPI 1 to GPI 5) to open the following popup where all
available functions are displayed:
Then choose a parameter (see table below, e.g. Switch Scene), then if needed a first and a second option
low, or on impulse (there is no threshold).
and is stable during 150 ms.
In case of competition between GPI functions (e.g. GPI1 is mute ON and GPI3 is mute OFF), note that the
last validated (after 150 ms) wins.
NXAMPmk2 will wait until GPI goes low to start the
amplifier. This GPI can be connected to another
NXAMPmk2 "Power Amp Started" GPO in order to start
amplifiers sequentially and reduce current rush on main
power supply.
Recalls a scene or another, or toggle between two scenes.
If "Active on High" is selected, scene A is recalled when
GPI is low, and scene B is recalled when GPI is high. If
"Active on Low", it is the opposite.
Mutes (or unmutes) all the analog inputs.
Mutes (or unmutes) all the digital inputs.
Put the NXAMPmk2 in stand-by mode (or back to running
mode). In case of Impulse mode, the stand-by action is
triggered only after 3 seconds.
Relatively increases the volume on all channels, 1dB for
each pulse. Even if maximum volume is reached on one
channel, continues increasing volume on other channels.
Relatively decreases the volume on all channels, 1dB for
each pulse. Even if minimum volume is reached on one
channel, continues decreasing volume on other channels.
Mutes (or unmutes) all the amplifier. Does not affect
individual channel mute.
Attenuates by 20dB (or not) all the amplifier.
Recalls a scene. It is possible to assign this function to
several pins to be able to switch between several scenes.
Mutes (or unmutes) one channel.
To Next Page
Loading...
Need help?
General
