NXAMPMK2 USER MANUAL PAGE 41 / 80
-defined
range.
Here are the parameters that can be configured:
MONITORING MODE
Here can be modified the Load Monitoring mode. 3 modes are available.
- OFF: The Load Monitoring is turned off. The impedance is not measured, no alerts are raised.
- Internal Generator: The Load Monitoring uses an internal HF burst generator and this signal is used to
measure the impedance of the connected speakers.
- External generator: The Load Monitoring uses an external HF pilot tone (sent to the NXAMPmk2 with
the audio program) and this signal is used to measure the impedance of the connected speakers.
To Next Page
Loading...
Need help?
General
