PAGE 34 / 80 NXAMPMK2 USER MANUAL
REMOTE CONTROL
IMPORTANT NOTE
On some extension cards, likes NXAEDT (Dante
TM
and AES/EBU), NXDT104mk2 (Dante
TM
) and NXAE104
(AES/EBU), a network switch is included on the extension card connecting the amplifier directly to the
network. So, with any of these cards, the card has an IP address and the NXAMPmk2 has also an IP
address.
All network settings available in this page are for the NXAMPmk2 amplifier itself.
In the NXDT104mk2 below example, the card IP address on Dante Controller is 192.168.1.42 (used for
Dante audio network), and the NXAMPmk2 IP address on NeMo is 192.168.1.27 (used for remote-control).
NXDT104mk2
DEVICE ID
Here can be modified the NXAMPmk2 Device ID.
The Device ID is always included in front of the Dante card name on the Dante network. On the following
Dante Controller screenshot, we can see that the Dante -NEXO-NXAMP4x4mk2-
The Device ID can be edited on Dante Controller by editing it directly in the Dante card name.
To Next Page
Loading...
Need help?
General
