NXAMPMK2 USER MANUAL PAGE 35 / 80
NAME
Here can be modified the NXAMPmk2 name.
This name is used and displayed by the remote-control software (NEXO NeMo).
NB: The NXAMPmk2 name is not the same than the Dante card name, but a function is available in NeMo
to sync them on request (see NeMo user guide).
MODE
Here can be modified the NXAMPmk2 IP mode. 2 modes are available from the following popup:
- network working easily.
When the amplifier starts, it asks an IP address on the network using a DHCP request. If no DHCP
server answers by giving an address, the amplifier switches automatically in Auto-Addressing mode and
takes an IP address in the auto-a
-
used in some cases when the NXAMPmk2 needs to be included in a wider existing network with a strict
structure already established (on fixed installations for example).
IP ADDRESS / NETMASK
Here can be the IP address and the Netmask.
In , the IP address and Netmask are displayed for information but are not editable.
A
a DHCP server has be connected by mistake on the network, to restart the addressing process and switch
back to Auto-Addressing.
the IP address and Netmask are displayed, and can be modified by clicking on it.
To Next Page
Loading...
Need help?
General
