8-5.
Run
Switch outputs will switch ON and OFF according to the designated setting values during Run.
Select the desired Program No.
Not required for VS-5E Model.
①
Set the key-switch to the SET position.
②
Select the desired Program No.
１
PROGRAM
Set the key-switch to the RUN position.
The “current position value” will then be displayed at the
POSITION display area.
Switch outputs will switch ON and OFF according to the
designated setting values.
The timing pulse output will switch ON and OFF according to
the current position value.
［
RUN Mode Display
］
To check a Switch output status while in the RUN mode,
designate the desired Switch No. The output status for that
Switch will then be displayed at the “Dog” display area.
ON
：
OFF
：
DOG DOG
１
１１
１
２
２２
２
┼
─
ｏ
SET
TEACH
CLEAR
INIT
RUN
SET
TEACH
CLEAR
INIT
RUN
POSITION
PROGRAM
DOG
SWITCH
SENSOROFFONSETCUR.EXT. NOR.
0.5
ON
OFF
SET
SET
TEACH
CLEAR
INIT
RUN
●C-6●
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
