Oki C834DN User Manual

- 82 -
Changing the Equipment Settings
3
3. Changing Printer Settings
Boot Menu
Item Factory Default Description
Boot Menu USB Setup USB Enable Sets whether to enable USB I/F.
Speed 480Mbps Sets the maximum transfer speed of USB I/F.
Soft Reset Disable Sets whether to enable the Soft Reset
command.
Ofine Receive Disable Sets whether to enable the function that
keeps the data receivable state with no
change of the I/F signal in case an error
occurs.
Serial Number Enable Sets whether to enable the USB serial
number.
Security Setup
(When SD
Memory Card is
installed)
Job Limitation Off Sets the limited job mode.
When the mode is set to [Encrypted Job],
printing data other than specied (only an
encrypted authentication print job can be
specied) is restricted.
Make Secure
SD Card
(NULL) Enables encryption of data saved on an SD
memory card.
Make Normal
SD Card
(NULL) Disables encryption of data saved on an SD
memory card.
Reset Cipher
Key
(NULL) Resets the cipher key used on an encrypted
SD memory card.
After this operation has been completed, all
data stored on the SD memory card cannot
be restored.
Storage Setup Check File
System
(NULL) Resolves mismatch between the actual
(available) memory and the available memory
displayed and performs recovery of the
administration data (FAT information) for
a le system. This operation is applied to
each le system. (When SD Memory Card is
installed)
Check All
Sectors
(NULL) Performs recovery of the defective sector
information on SD memory card and resolves
mismatch between the actual (available)
memory and the available memory displayed.
(When SD Memory Card is installed)
Enable SD Card Yes If the printer is not able to turn on due to a
damaged SD memory card, selecting [No]
enables the printer to turn on as if there is
no SD memory card installed even if an SD
memory card is installed to the printer. (When
SD Memory Card is installed)
Erase SD Card (NULL) This item is displayed only when an SD
memory card is installed.
This function erases all data on the SD
memory card. (When SD Memory Card is
installed)
Enable
Initialization
No Disables any changes that involve
initialization of the block device (SD memory
card, ash memory).
Language Setup Language
Initialize
(NULL) Initializes the message le loaded on the ash
memory.

Oki C834DN Specifications

General

Brand	Oki
Model	C834DN
Category	Printer
Language	English