5-7
Use by Connecting Software
Sysmac Studio FH tool, FZ_FH Remote Operation tool, and Simulation Software are dedicated soft-
ware.
5-7-1
Sysmac Studio FH Tool
Sysmac Studio FH tool is supported only FH-1000/2000/3000/5000 series.
When you purchase these series newly, both software DVD and icons are required.
Additional Information
For Sysmac Studio FH tool, refer to the Vision System FH Series Operation Manual for Sysmac
Studio (Cat. No. Z343).
5-7-2
FZ_FH Remote Operation Tool
FZ_FH Remote Operation tool is supported all of the series; FH-1000/2000/3000/5000, and FH-L ser-
ies.
When you purchase these series newly, both software CD-ROM and license are required.
Additional Information
For details of FZ_FH Remote Operation tool, refer to Remotely Operating the Controller
(Remote Operation) section in the Vision System FH/FHV series User’s Manual (Cat. No.
Z365).
5-7-3
Simulation Software
Using the Simulation Software, you can check the operation or functions of Vision System FH series
on a PC.
When you purchase these series newly, both software CD-ROM and license are required.
Additional Information
For using the Simulation Software, refer to the description of How To Use Simulation Software.
5 Setup and Wiring
5-28
FH Series Vision System Hardware Setup Manual (Z366-E1)
To Next Page
Loading...
Need help?
General
