6-5
Serial Interface
Serial interface of Sensor Controller differs by series. Refer to the correct information for the series
you are using.
RS-232C interface is used in FH-1000/2000/3000/5000 and FH-L series.
6-5-1
All Series
Precautions for Safe Use
• Use only the cables designed specifically for the product. Use of other products may result in
malfunction or damage of the product.
• Always turn OFF the power of the FH-L series Sensor Controller and peripheral devices be-
fore connecting or disconnecting a camera or cable. Connecting the cable with power sup-
plied may result in damage of the camera or peripheral devices.
• Since cables to which bending is frequently applied is easily broken, use the robotic cable
type (bending resistant cable) to prevent damages.
• Do not apply torsion stress to cables. If not, it may cause damage to cables.
• Secure the minimum bending radius of cables. If not, it may cause damage to cables.
Precautions for Correct Use
• Check the following items on the communications cables that are used in the network.
- Are there any breaks?
- Are there any shorts?
- Are there any connector problems?
• When you connect the cable to the communications connectors on devices, firmly insert the
communications cable connector until it locks in place.
• Do not lay the communications cables together with high-voltage lines.
• Do not lay the communications cable near devices that generate noise.
• Do not lay the communications cables in locations subject to high temperatures or high hu-
midity.
• Do not lay the communications cables in locations subject to excessive dirt and dust or to oil
mist or other contaminants.
Cable
• For communication cable, use a shielded twisted-pair cable.
• The maximum cable length is 15 [m].
How to Connect
• Align the connector to the socket and press it straight into place, then tighten it with the screws on
both sides of the connector.
Input and output Connector
Prepare the suitable connector. Recommended connector is the following table.
6 I/O Interface
6-39
FH Series Vision System Hardware Setup Manual (Z366-E1)
6-5 Serial Interface
6
6-5-1 All Series
To Next Page
Loading...
Need help?
General
