7-2-2
Environment Settings
The following preparations are required on the Smart Camera and a remote operation PC respectively
to launch the remote operation.
• Remote operation PC: Arrange communications and GUI environments for the remote operation.
• Smart Camera: Set up a server for the remote operation.
Install a PC software to the remote operation PC.
Precautions for Correct Use
Make sure that the software version installed on the remote operation PC should be the same
as that on the Smart Camera.
Precautions for Correct Use
In the remote operation, the following port numbers are used to communication with the Smart
Camera.
• 9900 + Line number (e.g. port 9900 for line 0)）
• 9910 + Line number (e.g. port 9910 for line 0)
• 9920 + Line number (e.g. port 9920 for line 0)
If these ports are disabled due to security settings of your PC or the domain security policy, the
remote operation is not available.
Reconsider the security settings of your PC or the domain security policy, or ask your domain
security administrator.
7-2-3
Network Settings for the Remote Operation PC
Set the IP address for the remote operation PC.
1 Open the Local Area Connection Properties on the remote operation PC.
2 Input the IP address.
7 Software Setup
7 - 11
FHV Series Smart Camera Setup Manual (Z408-E1)
7-2 Operating the Smart Camera Remotely [Remote Operation Tool]
7
7-2-2 Environment Settings
To Next Page
Loading...
Need help?
General
