7-2-4
Network Settings for the Smart Camera
Precautions for Correct Use
The network settings for the Smart Camera set with this procedure is temporary. Since the set-
tings are discarded with restarting the Sensor Controller or power off, perform the procedures of
7-2-5 Network Settings for the Smart Camera with Remote Operation Tool on page 7 - 14 after
the remote operation connected.
1 From Start menu on your PC, select All Programs - OMRON - FH_FHV Series - FH_FHV
Launcher.
The FH/FHV Launcher window appears.
2 Click Remote Operation Tool.
3 Specify the version if it has already been known.
All software versions installed in the PC will be displayed.
Additional Information
When data for Sensor controller project, System +Scene group 0, Scene group, Scene, and
Unit exist, the version of software to be run can be checked by specifying data. For details, refer
to Launching the Remote Operation Tool on page 7 - 6.
4 Click Run.
7 Software Setup
7 - 12
FHV Series Smart Camera Setup Manual (Z408-E1)
To Next Page
Loading...
Need help?
General
