Omron MX2 User Manual

111
"B" Group: Fine Tuning Functions Section 3-6
Refer to User parameter (U001~U032) section for the detail.
3. Data comparison display mode (b037=03)
The monitor displays only the parameters that have been changed from the
factory settings. All monitoring indications dxxx and code F001, b190, b191
are always displayed.
4. Basic display mode (b037=04)
The monitor displays basic parameters. (The monitor display is the factory
setting.) The following table lists the parameters that can be displayed in basic
display mode.
Initial display selection: b038 – The initial display selection function allows
you to specify data displayed on the integrated operator on powerup. The
table below lists the display items selectable. (The factory setting is 01 [d001].)
Panel display selection: B150 – When an external operator is connected to
MX2 via RS-422 port, the display is locked and shows only one parameter
configured by B150.
Automatic return to the initial display: b164 – 10 min. after the last key
operation, display returns to the initial parameter set by b038.
No. Code displayed Item
1 d001 ~ d104 Monitoring indication
2 F001 Output frequency setting
3 F002 Acceleration time (1)
4 F003 Deceleration time (1)
5 F004 Keypad Run key routing
6 A001 Frequency source
7 A002 Run command source
8 A003 Base frequency
9 A004 Maximum frequency
10 A005 [AT] selection
11 A020 Multi-speed frequency 0
12 A021 Multi-speed frequency 1
13 A022 Multi-speed frequency 2
14 A023 Multi-speed frequency 3
15 a044 V/F characteristic curve selection
16 a045 V/F gain
17 a085 Energy saving operation mode
18 b001 Restart mode on power failure / under volt. trip
19 b002 Allowable undervoltage power failure time
20 b008 Restart mode on over volt. / over curnt. trip
21 b011 Retry wait time on over volt. / over curnt. trip
22 b037 Function code display restriction
23 b083 Carrier frequency
24 b084 Initialization mode (parameters or trip history)
25 b130 Decel. overvoltage suppression enable
26 b131 Decel. overvoltage suppression level
27 b180 Initialization trigger
28 b190 Password A setting
29 b191 Password A for authentication
30 C021 Output [11] function
31 C022 Output [12] function
32
C036 Alarm relay active state

Omron MX2 Specifications

General

Brand	Omron
Model	MX2
Category	Inverter
Language	English