Introduction
Illustrations and Terminology in this manual
Thismanual explains using the default setting.
In principle, thismanual explains based on the following conditions:
When the tablet and keyboard base have been installed
When the keyboard and Touchpad are used for operation
Some illustrations are simplified to help your understanding and may look different from the actual unit.
Some types of software are automatically updated, and differencesmay occur from descriptions in thismanual.
If you do not sign in as an administrator, you cannot use some functions or cannot displaysome screens.
Thismanual explains operation procedures using the Touchpad or mouse as typical examples. In addition, you can touch the display screen to
operate the computer.
When using the touch operation, please replace the terms as described below, and read the instructions.
Operation terms to be replaced:
Click → Touch
Double-click → Double-touch
Right-click → Touch and hold (Long touch)
Terms and illustrationsin these instructions.
CAUTION: Conditions that may result in minor or moderate injury.
NOTE: Useful and helpful information.
≪ Enter≫ : Thismeans to press the Enter key.
≪ Fn≫ + ≪ F7≫ :
Thisillustration means to press and hold ≪ Fn≫ key, and then press≪ F7≫ key.
The display of the key may be different from this manual according to the keyboard used. (e.g. "Delete" instead of "Del")
- :
Click (Start) and then click (Power).
In these instructions, the names are referred as follows.
“Windows 10 Pro 64-bit” as “Windows” or “Windows 10”
“Multilanguage User Interface” as “MUI”.
The Digitizer + Touch Screen (Capacitive) as the “digitizer”, and the Touch Screen as the “touchscreen”.
The digitizer pen and the stylus as the “pen (included)”.
The computer screen supporting touching methods (using stylus / your fingers) is referred to as the "screen".
In thismanual, the tablet mode refers to the status where only the tablet is used.
Regarding Windows 10
Desktop mode and Tablet mode
Windows 10 offers the desktop mode in which operation is performed using the keyboard or Touchpad, and also the tablet mode optimized for the touch
panel operation.
The mode can be switched by clicking (Notification), and then clicking (Tablet mode) tile.
To Next Page
Loading...
Need help?
General