163
Stabiliser, Zoom and Flash
Setting the Flash Functions
Changing the firing mode (Manual flash)
Recording mode:
You can select whether the flash output is set automatically or manually.
This item is available only when the built-in flash is being used.
→ [Rec] → [Flash] → [Firing Mode]
[TTL] The camera automatically sets the flash output.
[MANUAL]
You can set the flash ratio manually. Even in the case of dark scenes where the flash
output tends to be higher in [TTL], this mode allows you to take a picture as intended.
The flash ratio (such as [1/1]) is displayed on the flash icon.
â–
Setting the flash ratio (When [MANUAL] is selected)
→ [Rec] → [Flash] → [Manual Flash Adjust.]
Press to select an item and press [MENU/SET]
• You can set the flash ratio from [1/1] (flash firing full power) to [1/128] in 1/3 steps.
To Next Page
Loading...
Need help?
General
